Sunbeam Series III, IV, V, Tiger Brake Reservoir Castrol Girling

Sunbeam Series III, IV, V, Tiger Brake Reservoir Castrol Girling. This is an original Girling Castrol Brake reservoir which was fitted to Tiger models directly to the brake master cylinder.

These came direct from Girling/Lucas USA when distribution ceased. Original part not reproduction. Girling reservoir has the correct notch located on the side / bottom which is required to install on the factory brake cylinder. Note this unit is centered and is not the offset replacement type. The Reservoir unit is complete with correct Castrol / Girling moulded cap and includes all securing hardware and rubber seals. The securing hardware bolt is 7/16 thread and will fit Girling and most aftermarket replacement with the same thread.  Tiger and Sunbeam AlpineSeries 3, 4, 5  brake master was 7/8 bore cylinder and fitted with a power boost  brakes ie Servo assist brake system.  Earlier Sunbeam models have a remote reservoir separate from the master cylinder. If you have the correct threaded female attachment brake nut this reservoir can also be mounted remotely and will only require an attachment bracket and pipe.

Important Girling reservoir is a center mount meaning the threaded mounting hardware is in the middle of the unit. Plastic reservoir  body is knocked to accept the cast flange of the Girling brake master cylinder. Note the notch is clearly visible in  the third picture of the galley and is on   the bottom of the reservoir.

1. Sunbeam Alpine Series III, IV, & V (remote or direct fit to master cylinder)
2. Sunbeam Tiger all models (direct fit to master cylinder) 

Original NOS Girling Reservoir 

Part No HBC 035

Original part with correct markings on the cap

Limited supply